Manual

6.0 BASICOPERATION

6.1 INITIALISATION

1) Whenthebalanceisfirstswitchedon,itwilldisplaythebalanceserialnumber

(ifset),softwarerevision,modelcapacityandthenallsegmentsonthedisplay

willbeshown.Overallthetimetakenisusually5‐10seconds.

2) If a passcode has been set, the display will show “PASSCODE” and the main

displaywillshowazero.Inthiscaseyoumustenterthepasscodetocontinue

using the numeric entry method (see section 5.1). A different passcode may

besetforaSupervisortoweighortohaveaccesstotheselectedUsermenus.

Ifthepasscodehasnotbeensetthebalancewillcontinueasbelow.

3) The display will show zero reading along with the zero symbol“→0←” and

the weighing unit last used.If automatic time calibration is enabled the

balancewillcalibrateafterpowerupandagainafterthepre‐settimeinterval.