Owner manual

© Adam Equipment Company 2009
10
• If a container is used, place the empty container on the pan before
entering parts counting mode then press [Tare] key to remove the
weight of the empty container. Then press [Func] key to go to parts
counting mode and select the preset sample piece value and add the
items to the container as selected and press [Zero] key.
• Press [Func] to exit and go back to the normal weighing mode.
5.4.2 PERCENTAGE WEIGHING
• In the weighing mode, press [Func] key twice to access the percentage
weighing mode, the display will show “PER”.
• Press [Zero] key to set the reference sample value, the display will
show “SE ”.
• Place the item to be set at 100% on the pan, and press [Zero] Key
when the stability indicator comes on.
• The display will show “100.0%”.
• When another item with a different weight value is put on the pan, the
relative % value would be shown against the initial reference sample
value.
• Press [Func] key to exit and go back to weighing mode.
5.4.3 CALIBRATION
• Refer to section 7 for details