Manual

P a g e 29 © Adam Equipment Company 2010
12.1.1 F1 -CALIBRATION
To enter the calibration parameter, press the [Tare] key when “F1” “CAL” is displayed.
The scale should be calibrated using a mass of approximately 2/3Maximum to
Maximum. If the scale has been calibrated previously the value will be stored.
Details of calibration are given is section 8.
12.1.2 F2 –PIN
• To enter this parameter, press the [Tare] key when “F2” “Pin” is shown.
• The “Weight” display will show “Pin 1”
• Enter the new password. The “Unit Weight” display will show dashes.
Press [Tare].
• The “Weight” display will change to “Pin 2 “, Enter the password again
and press [Tare].
• The display will show “donE” indicating the new password has been
accepted and will return to the menu. “F3” “Unit” is shown.
• Record the new password in a secured place.
• Press [Zero] to return to weighing.
12.1.3 F3 –Unit
• To enter this parameter, press the [Tare] key when “F3” “unit” is
shown.
• This parameter allows the user to enable or disable the weighing units
available in his scales.
• The display will show the first available weighing unit and if it is On or
Off.
• Press the [U.Wt./Units] key to change the value. Press [Tare] to
accept the displayed setting and go to the next unit.
• Press the [Zero] key to return to the menus. Press the [Zero] key again
to return to normal weighing.