Instruction Manual

REV. D PN J63091 - 10 -
Software Ver: Indicates software version
Troubleshoot: Shows various system inputs to aid startup issues
W-Meter Input:
W-Meter: Selects the type of water meter being used (dry contact or Hall
Effect)
Volume/Kfact: Sets the water meter volume per pulse or K-factor
Flow Units: Sets the units for flow display (gallons or liters)
Relay Output:
Stop Input: Relay activates when the stop input is active
Low 4-20 Alrm: Relay activates when 4-20mA input drops below the low
4-20mA alarm point
Hi 4-20 Alrm: Relay activates when 4-20mA input is above the high 4-
20mA alarm point
Circuit Failure: Relay activates when a circuit failure is detected
Pump Running: Relay activates when the motor is running
Wiring connections for the External I/O
WIRE FUNCTION
RED 4-20mA(+) /
W-METER(+)
BLACK 4-20mA(-) /
W-METER(-)
YELLOW STOP
VIOLET STOP
BROWN RELAY OUT(-)
BLUE RELAY OUT(+)
ORANGE +12VDC
WHITE HALL/Flow(SIG)
GREEN GND.
Dry contact water meter Hall-Effect water meter
Stop Input Connection Relay Connection 4-20mA Connection
5.1. General
DANGER: DO NOT ATTEMPT TO FEED CHEMICALS WITHOUT FIRST
CONSULTING YOUR CHEMICAL FEEDER DEALER OR CHEMICAL SUPPLIER. To
avoid running out of chemical, follow a regular schedule of monitoring chemical supply.