Instruction Manual

ManualsBrandsNOTIFIER ManualsControl panelNOTIFIER UniNet 2000 AFP-300 Fire Alarm Control Panel

Document 51996 AFP-300/400 NION Installation Rev. A1 03/04/03

Appendix A: The AFP-300/400

Database Conversion Utility

For UniNet™ versions 2.1 SP2 or later, when upgrading an AFP-300/400 NION from the NION-232B architec-

ture to the AFP-300/400 NION architecture, the 400DBConvert utility must be run.

IMPORIMPOR

IMPOR

ANTANT

ANT

: The W: The W

: The W

orkork

ork

station cannot be running during this conversion process. The conversion utility will alter existingstation cannot be running during this conversion process. The conversion utility will alter existing

station cannot be running during this conversion process. The conversion utility will alter existing

device IDs in the screen database to match the new format used by this NIONdevice IDs in the screen database to match the new format used by this NION

device IDs in the screen database to match the new format used by this NION

. Any UniL. Any UniL

. Any UniL

ogicogic

ogic

equations from the old system must be recreated after installing the new AFPequations from the old system must be recreated after installing the new AFP

equations from the old system must be recreated after installing the new AFP

-300/400 NION-300/400 NION

-300/400 NION

The conversion process has three main steps:

1. To run the conversion utility, open up Windows™ Explorer, go to the c:\UniNet\PlugIns directory, then

double click on 400DBConvert.exe.

Figure A-1: Accessing the Conversion Utility

www.PDF-Zoo.com

firealarmresources.com