Instruction Manual

18
Document 51996 AFP-300/400 NION Installation Rev. A1 03/04/03
1.10 Software Replacement/Upgrade Installation
When replacing or upgrading the software and network PLCCs, execute the following steps:
1. Disconnect all power to the AFP-300/400 NION.
IMPORIMPOR
IMPORIMPOR
IMPOR
TT
TT
T
ANTANT
ANTANT
ANT
: Always exercise ESD precautions: Always exercise ESD precautions
: Always exercise ESD precautions: Always exercise ESD precautions
: Always exercise ESD precautions
when directly handling the AFPwhen directly handling the AFP
when directly handling the AFPwhen directly handling the AFP
when directly handling the AFP
-300/400 NION or any other hardware.-300/400 NION or any other hardware.
-300/400 NION or any other hardware.-300/400 NION or any other hardware.
-300/400 NION or any other hardware.
2. Place the flash modules in their respective sockets according to the figure below. Orient the notch on the
chip with the notch in the socket.
3. Re-apply power to the NION.
Network Communication PLCC (U24)Network Communication PLCC (U24)
Network Communication PLCC (U24)Network Communication PLCC (U24)
Network Communication PLCC (U24)
Application PLCC (U6)Application PLCC (U6)
Application PLCC (U6)Application PLCC (U6)
Application PLCC (U6)
Figure 1-14: NION Software Replacement
www.PDF-Zoo.com
firealarmresources.com