Instruction Manual

10
Document 51996 AFP-300/400 NION Installation Rev. A1 03/04/03
Figure 1-2: AFP-300/400 NION Board Layout
3V Lithium3V Lithium
3V Lithium3V Lithium
3V Lithium
BatteryBattery
BatteryBattery
Battery
J1 Header for EchelonJ1 Header for Echelon
J1 Header for EchelonJ1 Header for Echelon
J1 Header for Echelon
Network TNetwork T
Network TNetwork T
Network T
ransceiverransceiver
ransceiverransceiver
ransceiver
Application PLCCApplication PLCC
Application PLCCApplication PLCC
Application PLCC
SW2 NetworkSW2 Network
SW2 NetworkSW2 Network
SW2 Network
Binding ButtonBinding Button
Binding ButtonBinding Button
Binding Button
SW1 ResetSW1 Reset
SW1 ResetSW1 Reset
SW1 Reset
ButtonButton
ButtonButton
Button
Network CommunicationNetwork Communication
Network CommunicationNetwork Communication
Network Communication
PLCCPLCC
PLCCPLCC
PLCC
SMX TSMX T
SMX TSMX T
SMX T
ransceiverransceiver
ransceiverransceiver
ransceiver
Standoff MountingStandoff Mounting
Standoff MountingStandoff Mounting
Standoff Mounting
HolesHoles
HolesHoles
Holes
ChassisChassis
ChassisChassis
Chassis
GroundGround
GroundGround
Ground
{
Diagnostic LEDSDiagnostic LEDS
Diagnostic LEDSDiagnostic LEDS
Diagnostic LEDS
R72 Cut TR72 Cut T
R72 Cut TR72 Cut T
R72 Cut T
o Disableo Disable
o Disableo Disable
o Disable
Ground Fault DetectionGround Fault Detection
Ground Fault DetectionGround Fault Detection
Ground Fault Detection
GND +24VDC
PP
PP
P
ower Input (TB5)ower Input (TB5)
ower Input (TB5)ower Input (TB5)
ower Input (TB5)
P2 Serial Interface BP2 Serial Interface B
P2 Serial Interface BP2 Serial Interface B
P2 Serial Interface B
NUP PNUP P
NUP PNUP P
NUP P
ort (EIAort (EIA
ort (EIAort (EIA
ort (EIA
-232)-232)
-232)-232)
-232)
TB6-Relay OutputTB6-Relay Output
TB6-Relay OutputTB6-Relay Output
TB6-Relay Output
U24U24
U24U24
U24
BT1BT1
BT1BT1
BT1
U6U6
U6U6
U6
TB1-Serial Interface ATB1-Serial Interface A
TB1-Serial Interface ATB1-Serial Interface A
TB1-Serial Interface A
P1 Serial Interface AP1 Serial Interface A
P1 Serial Interface AP1 Serial Interface A
P1 Serial Interface A
NUP PNUP P
NUP PNUP P
NUP P
ort (EIAort (EIA
ort (EIAort (EIA
ort (EIA
-232)-232)
-232)-232)
-232)
NOTES: The AFP-300/400 NION is only compatible with AFP-300/400 firmware
version 3.6 or later.
It is recommended that the installer conform to local code requirements when installing
all wiring. All power connections must be non-resettable. Refer to the current Notifier
catalog for specific part numbers and ordering information for each NION.
To avoid damage to hardware, always remove power from the NION before making
any changes to switch settings and removing or installing option modules, SMX network
modules and software upgrade chips.
Always observe ESD protection procedures.
J1J1
J1J1
J1
www.PDF-Zoo.com
firealarmresources.com