Instruction Manual
Table Of Contents
- Table of Contents
- Section 1 About This Manual
- Section 2 System Overview
- Section 3 Installation
- 3.1 Preparing for Installation
- 3.2 Installation Checklist
- 3.3 Mounting a Cabinet
- 3.4 Laying Out Equipment in Cabinet and Chassis
- 3.5 Installing the Control Panel
- 3.5.1 Control Panel Circuit Board & Keypad/Display Unit
- 3.5.2 Using NCA as Primary Display
- 3.5.3 Loop Expander Module
- 3.5.4 Network Control Module
- 3.5.5 Panel Circuit Modules and Other Option Boards
- 3.5.6 Overview
- 3.5.7 Connecting the Control Panel to AC Power
- 3.5.8 Checking AC Power
- 3.5.9 Installing and Connecting the Batteries
- 3.5.10 APS-6R Auxiliary Power Supply Connections
- 3.5.11 External DC Power Output Connections
- 3.5.12 NAC Connections & Releasing Circuits
- 3.5.13 Output Relay Connections
- 3.5.14 Backup-Alarm Switches
- 3.5.15 Installing a Transmitter Module TM-4
- 3.6 UL Power-limited Wiring Requirements
- 3.7 Installing Panel Circuit Modules
- 3.8 Auxiliary Relay Module (ARM-4): Product-Specific Details
- 3.9 Installing Remote Printers and/or CRT
- 3.10 Wiring a Signaling Line Circuit (SLC)
- Section 4 Applications
- Section 5 Testing the System
- Appendix A Power Supply Calculations
- Appendix B Electrical Specifications
- Appendix C Compatible Equipment
- Appendix D Canadian Applications
- Index
NFS-640 Installation Manual P/N 51332:B2 07/27/2004 55
Section 4 Applications
4.1 Overview
Municipal Box (Auxiliary)
Municipal Box applications require a TM-4 Transmitter module. Refer to the Transmitter Module TM-4
installation document for installation details.
Chapter Covers the following topics
Section 4.2 “NFPA 72-
1999 Central or Remote
Station Fire Alarm System
(Protected Premises Unit)”
How to install UDACT with the control panel for use as a NFPA Central
or Remote Station Fire Alarm System (Protected Premises Unit)
Section 4.3 “NFPA 72-
1999 Proprietary Fire
Alarm Systems”
How to set up a Protected Premises Unit to communicate with a listed
compatible Protected Premises Receiving Unit.
Section 4.4 “Fire/Security
Applications”
How to use the control panel as a combination Fire/Security system,
including the following:
• Installing a Security Tamper Switch into the cabinet
• Circuit Wiring
Section 4.5 “Releasing
Applications”
How to install the following releasing applications:
• a Releasing Device to the Control Panel (NAC integral circuits)
• a Releasing Device to the FCM-1 Module
• an NBG-12LRA Agent Release-Abort Station
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com