Instruction Manual

ManualsBrandsNOTIFIER ManualsCombiner RoutersNOTIFIER NCB-FL Series Network Combiner Routers

Document 51895 NCB-EL and NCB-FL Router Installation Rev. A 2/12/2002

Installing the NCB-FL in the NISCAB-5

The NCB-FL requires the installation of a fiber cable extension between the router module and the CentreCOM

Fiber Optic Transceiver.

1. Attach the fiber cable extension to

the CentreCOM transceiver, and

place them on the second shelf

below the router mounting shelf.

Mount the CentreCOM transceiver

to the shelf using the bracket

provided. Run the cable extension

behindbehind

behind the router mounting shelf

up to the router module.

2. Connect the network wires (or

fiber) to the SMX network trans-

ceiver.

4. Connect the fiber cable to the AUI

connector.

5. Connect the router transformer

power plug to the power connector

on the unit and slide the unit and

shelf into the cabinet.

6. Plug the router power transformer

into the electrical outlet.

Installing a PNET-1 in the NCB-EL Assembly

The PNET-1 is a surge suppressor that protects an Ethernet line from power surges. Install the PNET-1 into the

NISCAB-5 as shown in

Figure 1-15.

Connect the Ethernet cable from the 10Base-T Ethernet connector on the NCB-EL router to the PNET-1 IN connec-

tion (the square end). Run the Ethernet line from the OUT connection (the round end) to the LAN.

NISCAB-5NISCAB-5

NISCAB-5

PNETPNET

PNET

-1-1

-1

Shelf Unit for PNETShelf Unit for PNET

Shelf Unit for PNET

-1-1

-1

CoverCover

Cover

Star WStar W

Star W

asherasher

asher

PNETPNET

PNET

-1 Ground W-1 Ground W

-1 Ground W

ireire

ire

PNET-1 Installation Diagram

CentreCOM Fiber OpticCentreCOM Fiber Optic

CentreCOM Fiber Optic

ransceiverransceiver

ransceiver

NCB-FL Installation

Fiber cable extensionFiber cable extension

Fiber cable extension

MountingMounting

Mounting

BracketBracket

Bracket

www.PDF-Zoo.com

firealarmresources.com