Instruction Manual

ManualsBrandsNOTIFIER ManualsCombiner RoutersNOTIFIER NCB-FL Series Network Combiner Routers

Document 51895 NCB-EL and NCB-FL Router Installation Rev. A 2/12/2002

HSP-121B/NISCAB-5 Installation

Install Outlet Using SelfInstall Outlet Using Self

Install Outlet Using Self

apping Screws (Papping Screws (P

apping Screws (P

rovided)rovided)

rovided)

Install Edco HSPInstall Edco HSP

Install Edco HSP

-121B-121B

-121B

Using the Studs and NutsUsing the Studs and Nuts

Using the Studs and Nuts

as Shownas Shown

as Shown

NISCAB-5NISCAB-5

NISCAB-5

Electrical OutletElectrical Outlet

Electrical Outlet

Edco HSPEdco HSP

Edco HSP

-121B-121B

-121B

Nonpower-limited WiringNonpower-limited Wiring

Nonpower-limited Wiring

in Bottom of Cabinetin Bottom of Cabinet

in Bottom of Cabinet

NOTE: Power-limited and

nonpower-limited circuits must

remain separated in the cabinet.

All power-limited wiring must

remain at least 0.25 inches from

any nonpower-limited circuit

wiring. Run all non-power-limited

wiring along bottom of cabinet.

All power-limited and nonpower-

limited circuit wiring must enter

and exit the cabinet through

different knockouts and/or

conduits.

NCB-EL Router Installation Into the NISCAB-5

NOTE: Use only wire for power limited systems.

Power limited wire runs use type FPLR, FPLP, FPL

or equivalent cabling per NEC 760.

NCB Series RouterNCB Series Router

NCB Series Router

Shelf Unit for NCB RouterShelf Unit for NCB Router

Shelf Unit for NCB Router

NISCAB-5NISCAB-5

NISCAB-5

CoverCover

Cover

www.PDF-Zoo.com

firealarmresources.com