E3Point Make your operation run more intelligently to protect people, property and your bottom line
E3Point Toxic and Combustible Gas Monitor Flexible Operation • Comes in standalone, standalone with remote (dual gas mode) or network versions • Connects to analog or digital systems • Works with virtually any BAS including BACnet, Modbus or LonWorks* • Connects to wired or wireless system (via 301CW wireless controller) • Wall or duct mount • Factory-calibrated cartridges E3Point goes beyond protection to offer your building greater performance and productivity.
Flexible Applications E3Point integrates easily with your building’s analog or digital infrastructure as a standalone unit or network addressable device. Here are five installation examples to make E3Point work for you. E3Point Standalone Single-Sensor Operation E3Point/Modbus Configuration 301C A low-cost application for buildings with minimal gas monitoring requirements typical of a small facility. Offers easy installation, commissioning and operaton. Two on-board relays can activate fan or strobe.
Carbon Monoxide (CO) Nitrogen Dioxide (NO2) X TO Propane (C3H8) Methane (CH4) E3Point Hydrogen (H2) IC M M A BL E FLA Dual-Gas Detection In Many Combinations Hydrogen Sulfide (H2S) Oxygen (O2) E3Point Expands the Range of Gas Detection to Serve Practically All Building Areas, Including Outbuildings Building Environment Gases Present (Detected by E3Point) Parking Structure CO, NO2, C3H8 Loading Dock CO, NO2, C3H8,H2 Transport Terminal CO, NO2, C3H8,CH4 Golf Cart Maintenance/ Battery Chargi
