Owner manual

Canadian DN-60029:A • 2/21/07 — Page 3 of 4
Tone Selection
Chime tone selection is accomplished by using the rotary switch on the back
of the product. The current draw and sound measurements for various
chime tones are listed below.
Chime Current Draw,
ULC Maximum (mA RMS)
Sound Output (dBA), Chime and Chime/Strobe
SpectrAlert Advance Chime/Strobe Dimensions
Sound Pattern dB
8 – 17.5 Volts 16 – 33 Volts
DC
(mA)
FWR
(mA)
DC
(mA)
FWR
(mA)
1-Second Chime HIGH 34 50 58 51
1-Second Chime LOW 30 51 51 54
1/4-Second Chime HIGH 34 51 50 50
1/4-Second Chime LOW 31 51 50 52
Temporal ChimeHIGH30504854
Temporal Chime LOW 30 47 50 51
5-Second Whoop HIGH 32 52 34 54
5-Second Whoop LOW 30 40 34 52
One Test ChimeHIGH48495050
Switch
Setting Sound Pattern dB
8 – 17.5 Volts 16 – 33 Volts
DC
(dBA)
FWR
(dBA)
DC
(dBA)
FWR
(dBA)
1 1-Second Chime HIGH 82 85 85 85
2 1-Second Chime LOW 76 79 77 77
3 1/4-Second Chime HIGH 82 84 84 85
4 1/4-Second Chime LOW 76 78 78 78
5 Temporal Chime HIGH 85 90 90 93
6 Temporal Chime LOW 79 80 80 80
7 5-Second Whoop HIGH 87 93 92 97
8 5-Second Whoop LOW 80 83 83 83
9One Test ChimeHIGH82848486
Chime Patterns
Setting Repetition Rate dB Out
1 1-Second Chime HIGH
2 1-Second Chime LOW
3 1/4-Second Chime HIGH
4 1/4-Second Chime LOW
5 Temporal Chime HIGH
6 Temporal Chime LOW
7 5-Second Whoop HIGH
8 5-Second Whoop LOW
9 One Test Chime HIGH
7089dim1.tif