User Manual
ManualsBrandsNot Assigned ManualsExternal Storage EnclosuresStarTech.com 4 Bay Thunderbolt 3 NVMe Enclosure, For M.2 NVMe Solid State Drives, 1x DisplayPort Video & 2x TB3 Downstream Ports, Up to 40Gbps, 72W Power Supply 4 Bay M.2 SSD External Hard Drive Enclosure - storage enclosure - M.2 NVMe Card / PCIe (NVMe)
6
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Note: Ensure the M.2 Drive is properly seated, with the pins
making full contact, before proceeding to the next step.
5. Gently press down on the M.2 Drive until the notch on the
M.2 Drive is aligned with the hole for the Holding Screw.
6. While holding the M.2 Drive in place, secure the M.2 Drive
by replacing the Holding Screw that was removed in step 3,
using a Phillips Head Screwdriver.
7. Repeat steps 3-6 to instal the remaining M.2 Drives.
8. Replace the Drive Bay Cover that was removed in step 2.
9. Screw in the two Drive Bay Screws that were removed in
step one, using a Phillips Head Screwdriver.
(Optional) Connect a Thunderbolt 3 Peripheral
• Connect a Thunderbolt 3 Cable (sold separately) to one
of the Thunderbolt 3 Ports on the Enclosure and to a
Thunderbolt 3 Port on the Thunderbolt 3 Peripheral.
--Or--
• Connect a Thunderbolt 3 Peripheral directly to one of the
Thunderbolt 3 Ports on the Enclosure.
(Optional) Connect Displays
Note: Connect and setup the DisplayPort Enabled
Display Device before connecting and setting up the
Thunderbolt 3 Enabled Display Device.