Use and Care Manual

ENGLISH
8
Assembly of Wheels
Slide one #4 Flat Washer onto Axle Bolt (F) and 1.
insert Axle Bolt (F) into Wheel (G).
Put on one #5 Flat Washer. Insert Axle Bolt (F) 2.
with Wheel (G) into Base Support (I).
Add a second #5 Flat Washer and #6 Nut Cap. Use 3.
Wrench (H) to tighten the #6 Nut Cap.
Repeat steps to attach second Wheel (G) onto the 4.
other side of the Base Support (I).
Locking Main Unit to Storage Compartment
Place the Main Unit (A) onto the Storage Compartment (B) so that the two
side holes match up. Lock by tightening the Lock Screws as shown below:
PDF !"# "pdfFactory Pro" $#%&'( www.fineprint.cn
Attaching Cone Holder
Attach Cone Holder (N) to
opposite side of Cart Handle
or opposite side of Base Door.
(#7)
Nut
Cap
(#5)
Flat
Washer
(F)
Axle
Bolt
(G)
Wheel
(I)
Base
Support
(#6)
Flat
Washers