Use and Care Manual

ENGLISH
6
HOW TO OPERATE
Before rst use, clean the Top Housing, Bowl and Base by wiping it with a moist, non-
abrasive sponge or cloth and then drying it with a non-abrasive dry towel. Make sure
the Top Housing is securely attached atop the Popping Chamber before starting.
1. First, nd a at surface near an electrical outlet. Make sure your cord is away
from any water source. It is acceptable to use an extension cord if needed.
2. Plug in the appliance while switch is ipped to OFF position.
3. Remove Top Housing, and turn appliance ON by ipping the switch on the Base.
Allow the appliance to run for about 2 minutes to heat up Popping Chamber.
4. While Popping Chamber is heating, fill Kernel Cap with corn kernels (2 ounces).
NOTE: Unit pops up to 8 cups of popcorn per batch, while
the Bowl holds up to 24 cups of popcorn.
5. Turn unit OFF.
6. Pour kernels into the Popping Chamber and replace Top Housing.
7. Turn the unit ON, and soon you will hear the popping begin. Popcorn will begin
to tumble out of the opening in the Top Housing and into the bowl.
8. Once the kernels have stopped popping, turn unit OFF.
9. Tip POP-CANO™ HOT AIR POPPER forward to make sure
that all of the popcorn is out of the machine.
10. Repeat these steps two more times to completely ll the Bowl.