Use and Care Manual

ENGLISH

5. Assemble Base Support (F) into the bottom of the Storage Compartment (B) and secure with

four #4 Screws.

Assembly of Wheels

1. Place #7 Flat Washer onto #3 Bolt and insert into pre-

drilled hole on inside of Base Support (F).

2. Put #7 Flat Washer and #13 Sleeve Barrel on end of inserted #3 Bolt.

3. Attach the Wheel (E) to the #3 Bolt. Place #7 Flat Washer and #8 Locking Washer

on Wheel (E). Use the end of Wrench (J) with small notch to hold the #3 Bolt in

place. While holding #3 Bolt in place, tighten the #10 Nut Cap with Wrench (J).

4. Repeat on other side, following the directions above.

(#10)

Nut

Cap

(#8)

Locking

Washer

(#7)

Flat

Washer

(#7)

Flat

Washer

(#3)

Bolt

(#13)

Sleeve

Barrel

(F)

Base

Support

(E)

Wheel