Use and Care Manual
ENGLISH
6
HOW TO OPERATE
1. Wipe out the Beverage Bowl with a damp, non-abrasive cloth and dry. Wash Crown Topper,
Rods, Tier Bowls, Extension Spouts and Pump in warm, soapy water, rinse then dry.
2. After cleaning the unit, assemble the LIGHTED PARTY FOUNTAIN. Make sure the parts
are tted together tightly and the fountain feels sturdy and is properly aligned.
3. Find a stable surface near an electrical outlet. Unit must be level to operate
properly and to create the desired owing eect. Make sure your cord is away
from any water source. If needed, it is acceptable to use an extension cord.
4. Add beverage (LIGHTED PARTY FOUNTAIN holds 96 ounces of liquid) and ll to
the line on the inside of the Beverage Bowl. DO NOT ll above the line.
5. Plug unit in and turn on by ipping the toggle switch on the Lighted Base.
6. The liquid will begin to rise up the Rods, lter through the Tier Bowls and trickle out of the
Extension Spouts. At this time, adjust the Tier Bowls and Extension Spouts to desired ow.
7. Cups can be lled by holding them under the Extension Spouts as the beverage trickles out.
8. As the beverage level decreases, rell the Beverage Bowl and keep it at the maximum
ll level for best results. Make sure that unit is turned OFF before adding liquid.
9. The LIGHTED PARTY FOUNTAIN must remain level to ensure proper ow of beverage. Be
careful not to drop pieces of food into the Beverage Bowl. This would clog the ow of liquid.