Installation Guide

ENGLISH
9
HOW TO OPERATE
Before rst use, clean the inside of the unit by wiping with a moist, non-abrasive
sponge, towel or cloth and then wipe with a non-abrasive dry towel. Wipe down the
inside of the Kettle and be sure it is properly placed in the brackets before starting.
1. First, nd a at surface near an electrical outlet before starting. Make sure your cord
is away from any water source. It is acceptable to use an extension cord if needed.
2. Gather your popcorn making supplies: popcorn, seasonings, bowls or bags for
holding the popcorn, cooking oil, Kernel Measuring Cup and Oil Measuring Spoon.
(Kernel Measuring Cup and Oil Measuring Spoon are included with your unit).
3. Make sure Kettle is properly secured in support brackets and that the Kettle
motor is plugged in. NOTE: Kettle will not heat if plug is not fully inserted.
4. Plug in the appliance while switch is ipped to OFF position.
5. Turn appliance ON by ipping the switch on the top of the machine (see illustration above
for location of switches). Allow the appliance to run 3-5 minutes to heat up Kettle.
6. Once Kettle has heated, turn unit OFF before adding ingredients.
7. Use the Oil Measuring Spoon supplied with your POPCORN & CONCESSION
CART to add 3 tablespoons of your favorite popcorn cooking oil to the
Kettle. For every Measuring Cup full of kernels (6-oz.), add 3 spoonfuls (3
tbsp.) of oil. For best results, light vegetable oil is recommended.
8. Add 6-oz. popcorn kernels to the Kettle using supplied Kernel Measuring Cup.
9. Close the door and turn unit ON. Turn the light switch to the ON
position to turn on the light and activate the Popcorn Warmer.
10. In no time at all, you will hear the popping begin. Fresh, hot popcorn will
begin to burst out of the ip lids on the Kettle - just like at the theater!
11. Fill the Concession Stand shelves with your favorite candy and treats.
ON / OFF & Light/
Popcorn Warmer
Switches (rear)
Crank Handle
Stainless Steel Kettle