Use and Care Manual

ENGLISH

HOW TO OPERATE

• Fill a standard ice cube tray with water and place in

freezer until frozen. Remove ice from tray(s).

• Place the ELECTRIC SNOW CONE MAKER on a stable, waterproof

surface near an electrical outlet before starting.

• Always make sure that the cord is away from a water source.

• With Shaver Bowl placed on top of Base, place frozen ice cubes in Shaver Bowl.

• BE CAREFUL when placing ice cubes in Shaver Bowl. The blade in the Shaver Bowl is

very sharp.

• Place a cone under the Shaver Bowl to catch the shaved ice.

• Place the Motor Cabinet on top of the Shaver Bowl and hold in place. When lled with

ice, the Motor Cabinet will rest a few inches above the bottom of the Shaver Bowl.

• Plug in the unit. The ELECTRIC SNOW CONE MAKER operates at one speed. While holding the

Motor Cabinet steady with one hand, press the Power Button. It will start with a gentle press.

• Press continuously until majority of ice is shaved, or until the Motor Cabinet sits ush on

the bottom of the Ice Bowl. To stop shaving ice, release pressure on the Power Button.

• Some ice may remain in the Shaver Bowl. Discard this ice before adding a new ice cube.

• Repeat the process until you have the desired amount of shaved ice.

• After each 1 minute of continuous use, wait 10 minutes

before using again to allow motor to cool.

• Unplug unit from outlet when nished.

HELPFUL TIPS

USING TRADITIONAL ICE CUBES

• Place 10 medium-sized ice cubes in an even layer in Shaver

Bowl to yield approximately 2 cups of shaved ice.

• Do not overll Shaver Bowl with ice.