Use and Care Guide

ENGLISH
7
Place Lid on unit and line up arrows on 5.
Lid and Blending Chamber. This is a
safety feature and the unit will not turn on
without the Lid in the correct position.
You can add additional liquid at 6.
any time by opening the Clear
Window in the Lid. Add more
liquid after mixing to reach desired consistency.
Plug in unit and turn ON by flipping the switch upward to ON position. 7.
Blend for approximately 10 minutes or until mixture 8.
has reached the desired consistency.
While the unit is still on, place glass underneath the Spout and dispense 9.
the beverage by lifting the Spout handle up. It is recommended to place
a towel or other cloth on the table or countertop underneath the Spout
to protect against any drips. NOTE: the Spout has a locking upright
position for filling multiple drink glasses or a pitcher of drinks.
If the Spout drips after dispensing, place a glass or container underneath 10.
Spout and open and close the valve by pushing down on the Spout
Handle once or twice quickly. Small ice chips can sometimes get
caught in the gasket, preventing it from closing completely.
Turn off the unit when desired consistency is achieved and it will 11.
keep your beverage cold until ready to dispense again.
Always dispense beverage with the appliance turned ON. Allow the unit to 12.
run for 8 seconds to mix before dispensing if unit has been sitting. When
you have finished, turn side knob to OFF position and unplug unit.
ON OFF