Use and Care Manual

PARTS & ASSEMBLY

9. Set the umbrella in the receptor hole located between the rollers and the small

warming compartments. Should you choose to leave the umbrella off at this point of

the assembly process, insert the white silicone cap provided into the receptor hole,

and your LARGE HOT DOG CART AND UMBRELLA™ is now ready to use.

Use and display your LARGE HOT DOG CART AND UMBRELLA™ with pride and have

fun with it!

HOW TO USE

(a)

Using the water heat feature…

To use your LARGE HOT DOG CART AND UMBRELLA™ with the water heat feature, you

will need to assure that the water outlet valve located on the underside of the cart (directly

below the warming trays) has been screwed tightly in place.

Remove one of the warming food trays and cover by pulling out the small red latches that

secure the tray to the cart. This will enable you to add water to the water tank. Pour

approximately 12 to 15 cups of water directly into the water tank. Push the water heater

button ON. This is located with the power and heat controls on the right side of the cart

(located under the pulling bar assembly/side shelf tray). Reposition the warming food tray

and cover and replace the small red latches. Allow the water to heat about 1/2 hour.

POWER AND HEAT SELECTION CONTROL PANEL

WARMING FOOD

At this time, you may fill the warming food trays with food (such as chili, potatoes,

sauerkraut, etc.) you want to warm up as your water heats. Allow approximately 10 minutes

to pre-heat.

TIPS:

1. The three smaller warming food trays will also generate hot contents.

Condiments and food that you do not want hot may be placed on the front upper

shelf.

2. Put hot dog buns or other bread items into warming food trays about 5 minutes

before you are ready to serve. Placing them in the warming food trays too early

can cause the bread to become hard.

COOKING FOOD

You can also use the warming food trays to boil hot dogs. Simply put a small amount of

water into the warming food tray, add your wieners, and boil them instead of placing on the

rollers grill.

Roller

Temperature

Control

Water Heater Switch

Roller Motor Switch