Use and Care Manual

ENGLISH

Assembly of Base Support

Push Handle (E) attaches onto the Concession Stand (C) 1.

using four #1 Screws and four #5 Flat Washers.

Insert Cross Bar (J) into the square inserts on the inside of Base Support 2.

(I) and secure from below with two #1 Screws and two #5 Flat Washers.

Insert the Leg Assembly (K) into the square inserts between the ends

of the Base Support (I) and fasten from inside with two #2 Bolts, four

#4 Flat Washers, two #2 Spring Washers and two #6 Nut Caps. Also

secure from above with two #1 Screws and two #5 Flat Washers.

Assemble Base Support (I) into the bottom of the Concession Stand 3.