Use and Care Manual

ENGLISH
7
ASSEMBLY OF THE WHEELS
1. Insert #3 Axle Bolt into Base Support (G).
2. Put on #6 Flat Washer. Slide one Wheel (F) into #3 Axle Bolt and
add a #5 Flat Washer and a #7 Nut Cap.
3. Use #2 Wrench (L) to tighten the #7 Nut Cap.
4. Insert the second #3 Axle Bolt to the other side of Base Support (G), add #6
Flat Washer, second Wheel (F), another #5 Flat Washer, and #7 Nut Cap to
the other side of the #3 Axle Bolt, following the directions above.
5. Use #2 Wrench (L) to tighten the #7 Nut Cap.
ASSEMBLY OF THE MAIN UNIT
1. Assemble Base Support (G) into the bottom of the Main
Unit (C) and secure with four #2 Bolts.
2. Push Handle (E) attaches onto the Main Unit (C) using four of the supplied #1 Screws
and four #5 Flat Washers. Attach Display Tray (D) to Main Unit (C) using four #1 Screws.
3. Attach Bowl (A) to Main Unit (C) by placing Bowl (A) over collar and
turning clockwise. Attach Dome to Bowl using three #10 Screws.
CHANGING THE FUSES
The Fuses are marked under each fuse compartment. Two
extra 10 Amp fuses are also included with this unit.
1. Using a at head screwdriver, push in, turning counter-clockwise.
2. Fuse is then accessible and can be changed. Once changed,
push in and turn clockwise to lock fuse into place.