Use and Care Manual

ENGLISH
6
PARTS & ASSEMBLY
HARDWARE
#1 Screw (10mm) #2 Bolt (10mm) #3 Axle Bolt (95mm)
Qty. 8 Qty. 8 Qty. 2
#4 Bolt (60mm) #5 Small Flat Washer #6 Large Flat Washer #7 Nut Cap
Qty. 2 Qty. 10 Qty. 4 Qty. 4
#8 Extra Fuses #9 Extra Kryptol #10 Screw (6mm)
(10 Amp) Qty. 2 Qty. 2 Qty. 3
PARTS
(A) Bowl & Dome (B) Sugar Shovel (C) Main Unit (D) Display Tray
(E) Push Handle (F) Wheels (G) Base Support (H) Leg Assembly
(I) Cross Bar (J) Screwdriver (K) Wrench #1 (L) Wrench #2
ASSEMBLY OF BASE SUPPORT
1. Insert Cross Bar (I) into the square inserts on the inside of Base Support (G)
and secure from below with two #2 Bolts and two #5 Flat Washers.
2. Insert the Leg Assembly (H) into the square inserts between the ends of
the Base Support (G) and fasten from inside with two #4 Bolts, two #6 Flat
Washers and two #7 Nut Caps and from the top with two #2 Bolts.