Use and Care Manual
ENGLISH
8
HOW TO OPERATE
Before rst use, remove all adhesive tape from the
drawers, shelves, trays and drain tube plug.
INSTALLATION
1. The beverage cooler should be placed on a completely at surface. Allow 1 foot of space
on each side of the beverage cooler and between the beverage cooler and the wall. Also
allow at least 8 inches of space between the top of the beverage cooler and the ceiling.
2. Choose a location for your beverage cooler that is not exposed to sunlight, high
temperature or humidity, as humidity may stain and damage the beverage cooler.
3. The surface of the location where the beverage cooler is installed should be
rm and at. If beverage cooler is not secured in a proper location, noise and
vibration may occur. The noise may be increased if the oor is not rm. If you have
to position the beverage cooler on a carpeted oor, place a sheet underneath
the beverage cooler to prevent heat emissions from ruining the carpet.
4. Make sure that legs are pressed rmly into the oor and allow the beverage
cooler to lean backward slightly so that the doors remain closed.
ADJUSTING TEMPERATURE
The temperature of the beverage cooler can be controlled manually by the temperature
control knob. The temperature control knob is located on the backside of the
beverage cooler on the outside of the unit. However, the number shown on the knob
does not correlate to the degrees. The
higher the number, the lower the interior
temperature of the beverage cooler will
be.
LIGHT SWTICH
The light switch located in the back of the
unit controls the LED lights that illuminate the
double-pane glass door. To turn o these lights,
simply turn the light switch to the OFF position.
PACKING AND MOVING
Save packing materials if possible and remember how materials are packed
in the box. Repack beverage cooler and accessories carefully.
DO NOT lift or pull the doors or door handles during transportation.
When moving, do not tilt appliance more than 45 degrees. Be very careful not to bump the
beverage cooler into anything.