Use and Care Manual

ENGLISH
6
PARTS & ASSEMBLY
Your COMMERCIAL FONDUE FOUNTAIN requires little assembly.
Prior to use, wipe out Bowl with a damp cloth and dry. Wash
Auger and Tower in warm, soapy water, rinse, then dry.
After cleaning, assemble fountain by following these steps:
Attach Bowl to top of Base by aligning the notches in the bottom of •
the Bowl to the notches on top of Base and securing in place.
Make sure Auger is securely in place •
by aligning the opening on the bottom
of the Auger with the Base Pin.
Attach Tower to Bowl by aligning the holes in the •
bottom of the Tower with the pins in the Bowl.
Place Tower Bowl on top of Tower. •
DO NOT attempt to place Auger or Tower on Base or remove from Base while the
motor is running. Make sure the Tower is fitted on the posts in the Base properly.
Tower
Auger
Bowl
Base