Product Manual

Figure 5
Figure 3
Figure 10
3-PT. PTO ROUGH CUT MOWER OWNER’S MANUAL
4 of 14
Step 2:
Remove the wired-on PTO shaft, the lift pins,
and the spacers. Loosen and remove the bolts
four (4) on the lift arm bracketsthat secure the
lift arm support straps, the lift arms, and the
lift arm braces (from the shipping positions)
and set all pieces aside (Figure 2).
Step 3:
Remove PTO shaft, lift pins, and spacers
Step 4:
Install the right lift arm and lift arm support
strap using two (2) short bolts and one (1)
lift pin(Figure 3). Note: The lift arm support
strap has one hole punched larger than
the other. The larger hole is to be used to
fasten with the lift pin. The lift arm & support
straps should be fastened to the outside of
the lift arm bracket.
Figure 1
• Use only accessories that are recommended by the manufacturer for use with your mower.
Accessories that may be suitable for one product may create a risk of injury when used with
another tool.Never use an accessory that has a lower operating speed or operating pressure
than the tool itself.
• Keep guards in place and in working order.Never operate the mower without the guards in
place.
• Do not leave the mower running unattended.
Assembly Instructions
Step 1:
Place the mower on a flat level surface
(Figure 1).
Step 5:
Loosen and remove the two (2) nuts and
washers for the A-frame tailwheel section,
leaving the bolts in place (Figure 4).
Figure 2
Figure 4
3-PT. PTO ROUGH CUT MOWER OWNER’S MANUAL
5 of 14
Step 7:
Install the long top mounting bolt by inserting
it through the hole in the left side lift arm brace,
the lower of the two (2) holes in the left side lift
arm, the spacer, the lower of the two (2) holes
in the top of the right side lift arm (which
should not be attached to the lift arm bracket
at this time), and finally through the right side
lift arm brace. Install a washer and start the
nut on the bolt, but do not tighten it at this
time (Figures 6-8).
Note: You may have to move the assembly
around to start the nut and washer. If you
are unable to get the nut and washer started,
a ‘C’ clamp may be necessary to compress
the assembly in order to start the nut & washer.
Step 6:
Install both the right and left side lift arm
braces by sliding them over the two (2)
A-frame tailwheel bolts that were loosened
in Step 4. Start the nuts on the bolts, but at
this time DO NOT TIGHTEN THEM. Allow
the lift arm braces to rotate forward and
rest against the installed lift arm (Figure 5).
Step 8:
Using the right side lift arm as a lever, pull to
the outside of the lift arm bracket and insert
the bolt through the lift arm and the lift arm
bracket. (See Figure 9.) Install the washer
and nut. Place the lift pin in the larger of the
two (2) holes on the lift arm brace and
loosely attach the lift arm. Finally, inset
the bolt, nut, and washer to lower the
section of lift arm support strap to lift
the arm bracket (Figure 10).
Figure 6
Figure 7
Figure 8
Step 9: Tighten all nuts and bolts.
Figure 9