Product Manual

Page 9 of 21
Step 5: Loosen and remove the two (2) nuts and washers for the A-frame tailwheel section, leaving
the bolts in place (Figure 4).
Step 6: Install both the right and left side lift arm braces by sliding them over the two (2) A-frame
tailwheel bolts that were loosened in Step 4. Start the nuts on the bolts, but at this time DO NOT
TIGHTEN THEM. Allow the lift arm braces to rotate forward and rest against the installed lift arm
(Figure 5).
Step 7: Install the long top mounting bolt by inserting it through the hole in the left side lift arm brace,
the lower of the two (2) holes in the left side lift arm, the spacer, the lower of the two (2) holes in the
top of the right side lift arm (which should not be attached to the lift arm bracket at this time), and
finally through the right side lift arm brace. Install a washer and start the nut on the bolt, but do not
tighten it at this time (Figures 6-8).