Product Manual
Page 8 of 21
Assembly Instructions
Step 1: Place the mower on a flat level surface (Figure 1).
Step 2: Remove the wired-on PTO shaft, the lift pins, and the spacers. Loosen and remove the bolts
four (4) on the lift arm brackets that secure the lift arm support straps, the lift arms, and the lift arm
braces (from the shipping positions) and set all pieces aside (Figure 2).
Step 3: Remove PTO shaft, lift pins, and spacers
Step 4: Install the right lift arm and lift arm support strap using two (2) short bolts and one (1) lift pin
(Figure 3). Note: The lift arm support strap has one hole punched larger than the other. The larger
hole is to be used to fasten with the lift pin. The lift arm & support straps should be fastened to the
outside of the lift arm bracket.