Product Manual

Page 7 of 12
Mounting Non-ASAE Implements
If the implement does not have ASAE specifications, use an adapter bracket (not provided) to mount it
to the Quick Hitch as illustrated below.
1. Remove the top hook by taking out the two hex bolts (2), lock washers (6), and a nut (7). Save
the hardware.
2. Slide the adapter bracket (not provided) over the top bracket of the Quick Hitch, and attach the
top link pin (not provided).
3. For most implements, the front hoe (closest to the implement) is recommended for the best
vertical alignment.
4. Attach the implement to the adapter bracket tab with a link pin (not provided).
5. Check that all connections are tight before starting the work task.
Before Each Use
When using this Quick Hitch, basic safety precautions should always be followed to reduce the risk of
personal injury and damage to equipment. Read all instructions before using this Quick Hitch!
1. Keep work area clean. Cluttered areas invite injuries.
2. Store idle equipment. When not in use, tools must be stored in a dry location to inhibit rust.
Always lock up tools and keep them out of reach of children.
3. Do not overreach. Keep proper footing and balance at all times.
4. Maintain tools with care. Keep tools clean for better and safer performance.
5. Remove adjusting keys and wrenches. Check that keys and adjusting wrenched are removed
from the tool or machine work surface before plugging it in.
6. Check for damaged parts. Before using any tool, any part that appears damaged should be
carefully checked to determine that it would operate properly and perform its intended function.
Check for alignment and binding of moving parts, any broken parts or mounting fixtures, and
any other condition that may affect proper operation. Any part that is damaged should be
properly repaired or replaced by a qualified technician.