Product Manual

Page 6 of 18
 Chemicals are toxic. Wear rubber gloves during operation. Seek medical attention immediately if
chemicals are ingested.
 Keep bystanders at least 50 feet away while operating.
 DO NOT operate or transport on steep inclines.
 DO NOT exceed this implement’s maximum speed of 5 MPH. Exceeding this speed may result in
loss of control during transport or braking.
 DO NOT use if the implement is damaged. Repair before continuing use.
 Park and store on a hard, level surface.
 Store out of reach of children. Not for use by or around children.
ROTATING PARTS HAZARD
To prevent serious injury or death:
 Never allow riders on the tractor or equipment.
 Keep hands and feet clear from rotating paddles while operating.
 DO NOT stand on or near the implement at any time.
 DO NOT stand between the tractor and the implement.
 DO NOT operate with bystanders in the area.
 Turn the engine off and detach the implement before servicing.
Assembly Instructions
Tractor Requirements & Preparation
The 3-point mounted broadcast spreader with a PTO drive will fit most category 1 and some category
0 tractors. Larger category 2 tractors may also be used if the 3-point hitch lift arms will narrow to 26
inches. Bushings will be needed to fit the category I (7/8” dia.) lift pins.
Note: Some category 0 tractors have very short lift arms or 5/8” diameter (Cat. 0) lift arm ball ends.
These tractors are not usually suitable.
Check the tractor’s 3-point hitch. The hitch hydraulic system should be able to hold the lift arms at a
set height.
Note: The #51447 spreader weighs 96 pounds and can hold up to 500 pounds of fertilizer. The
#51462 model can hold up to 1100 pounds of fertilizer. The tractor needs to be large enough to
handle this possible pound load safely. The tractor may have to be equipped with front end weights to
be properly counter-balanced.
Check the shield over the PTO stub shaft. Make sure it is in good condition and bolted securely to the
tractor. Purchase a new shield if the old shield is damaged or missing.
⚠CAUTION
Be sure your tractor is in good condition. Read all the safety precautions and make sure all tractor
operators are familiar with the safety rules of operation.
Packing
The spreader is shipped assembled, except for the PTO drive shaft.
Assembly & Mounting
Mount the spreader on your tractor by sliding the lift arm ball sockets over the spreader pull pins and
secure with linch pins (not furnished). Attach the center link (not furnished) to the center link bracket