Manualshelf

Product Manual

ManualsBrandsNorTrac ManualsAuger Powerheads, Bits + Extensions3-Pt. PTO Post Hole Digger — 9in. Dia. Auger, Cat-1
12345678910
Page 8 of 22
6. Using a 9/16” wrench, remove the shear bolt. Use a hex screwdriver to loosen the jam nut off
the screw enough to clear the internal bore of the PTO shaft.
7. Attach the auger to the output shaft on the bottom of the gear box using the 1/2” x 3” hex cap
grade 5 screws, 1/2” lock washers, and 1/2” hex nuts. Tighten the nuts using the provided
ratchet holes, if needed.