Product Manual

Page 11 of 22
⚠CAUTION
DO NOT overfill the gearbox. This could cause damage to the oil seals and
can cause permanent damage to the gearbox (which is not covered under
warranty).
4. Replace and tighten the check plug.
5. Replace and tighten the 1/2” vented pipe plug and clean off any excess oil.
Attaching to the Tractor
Never stand between the tractor and the digger while backing up the tractor to the hitch.
Note: For safety, it’s recommended that two people attach the digger to the tractor.
1. Place the tractor and the digger on level ground and inspect for defects to make sure all
guards and shields are in place.
2. Set the digger in an upright position on the ground. While one person carefully balances the
digger, the other person attaches the boom to the top link mounting bracket and the A frame
to the lift arms on the tractor.
3. Raise the digger to allow enough room to install the auger. Attach the auger to the bottom of
the gearbox.
4. Attach the PTO driveline to the tractor and to the digger’s gearbox input shaft, and secure the
anti-rotation chains.
5. Determine if the PTO shaft needs to be shortened.