Product Manual

Page 6 of 10
Specific Operation Warnings
To prevent serious injury or death:
 Read and understand the Owner’s Manual before operating, servicing, or repairing equipment.
 Stop the engine, remove the key, and set the brake before dismounting the tractor.
 Operate from the tractor seat only.
 Never allow riders on the equipment.
 DO NOT stand between the implement and the tractor.
 Keep hands and feet clear from the shovel while engine is on.
 Keep bystanders at least 50 feet away while operating.
 DO NOT operate or transport on steep inclines.
 DO NOT exceed this implement’s maximum speed of 5 MPH. Exceeding this speed may result in
loss of control during transport or braking.
 DO NOT use if the implement is damaged. Repair before continuing use.
 Park and store on a hard, level surface.
 Store out of reach of children. Not for use by or around children.
 To prevent property damage, watch for and avoid catching the shovel/shoe on stumps, large
rocks, and other immovable objects.
FALLING OFF CAN RESULT IN IMPALEMENT OR BEING RUN OVER.
 The tractor must be equipped with a Roll Over Protection Structure (or ROPS CAB) and a seat
belt. Keep a foldable ROPS system in the “locked up” position at all times.
 Keep the seat belt securely fastened.
 Never allow riders on equipment.
RAISED EQUIPMENT CAN DROP AND CRUSH.
 Before servicing, follow all instructions and safety rules in the Owner’s manual and securely block
all corners of the equipment with jack stands.
 Securely blocking prevents equipment dropping due to mechanical component failures.
FALLING OFF OR FAILING TO BLOCK SECURELY CAN RESULT IN SERIOUS INJURY OR
DEATH.
Assembly Instructions
Refer to the parts diagram in this manual to get an idea of how the parts need to be assembled for
each individual implement.
1. Make sure the lower draw pins (pull pins) are installed correctly for your tractor. Hitch pins should
be assembled outward for category I hitches.
2. Insert the hitch pins into the ball sockets in the lower lift arms of the tractor’s 3-point hitch. Lock in
place with linchpins (not furnished.) Attach the mast of the 3-point main frame by installing the
tractor’s center link (top link) with a top link pin (not furnished.)
3. Adjust the top link assembly to obtain the correct angle of the implement. Check the tractor’s 3-
point lift arms and adjust to level the implement from side to side.