Product Manual
Page 6 of 14
Read and understand the Owner’s Manual before operating, servicing, or repairing the
equipment.
Stop the engine, remove the key, and set the brake before dismounting the tractor.
Operate from the tractor seat only.
DO NOT operate without guards in place and in good condition.
Never allow riders on equipment.
Keep bystanders at least 50 feet away while operating.
DO NOT operate or transport on steep inclines.
DO NOT exceed this implement’s maximum speed of 5 MPH. Exceeding this speed may result in
loss of control during transport or braking.
When using the rear blade in the reverse direction, do not ram large dirt and snow piles.
DO NOT use if the implement is damaged. Repair before continuing use.
Park and store on a hard, level surface.
Store out of reach of children. Not for use by or around children.
FALLING OFF CAN RESULT IN IMPALEMENT OR BEING RUN OVER.
The tractor must be equipped with a Roll Over Protection Structure (or ROPS CAB) and a seat
belt. Keep the foldable ROPS system in the “locked up” position at all times.
Keep the seat belt securely fastened.
Never allow riders on equipment.
RAISED EQUIPMENT CAN DROP AND CRUSH.
Before servicing, follow all instructions and safety rules in this Owner’s Manual and securely block
all corners of the equipment with jack stands.
Securely blocking prevents equipment dropping from mechanical component failures.
FALLING OFF OR FAILING TO BLOCK SECURELY CAN RESULT IN SERIOUS INJURY OR
DEATH.
Assembly Instructions
THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE THOROUGHLY UNDERSTOOD
BEFORE ATTEMPTING TO BEGIN ASSEMBLING THIS MACHINE
Select an area for assembly that clean and free of any debris which might cause persons working
on the assembly to trip.
Do not lift heavy parts or assemblies. Use crane jack, tackle, fork trucks or other mechanical
device.
Never put hands, or any part of body, under blocked up assemblies if at all possible
After completing assembly, thoroughly inspect the machine to be sure that all nuts, bolts,
hydraulic, fittings or any other fastened assemblies have been thoroughly tightened.
Before operating equipment--If you have any questions regarding the proper assembly or
operations, contact your dealer or the manufacturer