Product Manual
Page 6 of 13
Specific Operation Warnings
To prevent serious injury or death:
Read and understand the Owner’s Manual before operating, servicing, or repairing equipment.
Stop the engine, remove the key, and set the brake before dismounting the tractor.
Operate from the tractor seat only.
DO NOT operate without guards in place and in good condition.
Never allow riders on equipment.
Keep bystanders at least 25 feet away while operating.
DO NOT operate or transport on steep inclines.
DO NOT exceed this implement’s maximum speed of 5 MPH. Exceeding this speed may result in
loss of control during transport or braking.
When using the rear blade in the reverse direction, do not ram large dirt and snow piles.
DO NOT use if the implement is damaged. Repair before continuing use.
Park and store on a hard, level surface.
Store out of reach of children. Not for use by or around children.
FALLING OFF CAN RESULT IN IMPALEMENT OR BEING RUN OVER.
The tractor must be equipped with Roll Over Protection Structure (or ROPS CAB) and seat belt.
Keep foldable ROPS system in the “locked up” position at all times.
Keep the seat belt securely fastened.
Never allow riders on equipment.
RAISED EQUIPMENT CAN DROP AND CRUSH.
Before servicing, follow all instructions and safety rules in the Owner’s Manual and securely block
all corners of equipment with jack stands.
Securely blocking prevents equipment dropping from mechanical component failures.
FALLING OFF OR FAILING TO BLOCK SECURELY CAN RESULT IN SERIOUS INJURY OR
DEATH.
Assembly Instructions
1. Select an area for assembly that is clean and free of any debris which might cause persons
working on the assembly to trip.
2. Do not lift heavy parts or assemblies. Use a crane, jack, tackle, fork trucks, or other mechanical
devices.
3. If the assembly instructions call for parts or assemblies to be blocked up, use only blocking
material that is in good condition and is capable of handing the weight of the assembly to be
blocked. Also insure that the blocking material is on a clean, dry surface.
4. Never put hands, or any part of body, under blocked up assemblies, if at all possible.
5. After completing the assembly, thoroughly inspect the machine to be sure that all nuts, bolts,
hydraulic fittings, or any other fastened assemblies have been thoroughly tightened.