Product Manual
Page 6 of 14
Specific Operation Warnings
To prevent serious injury or death:
Read and understand this Owner’s Manual before operating, servicing, or repairing equipment.
Stop the engine, remove the key, and set brake before dismounting the tractor.
Operate from the tractor seat only.
DO NOT operate without guards in place and in good condition.
Never allow riders on equipment.
Keep bystanders at least 25 feet away while operating.
DO NOT operate or transport on steep inclines.
DO NOT exceed this implement’s maximum speed of 5 MPH. Exceeding this speed may result in
loss of control during transport or braking.
When using the rear blade in the reverse direction, do not ram large dirt or snow piles.
DO NOT use if the implement is damaged. Repair before continuing use.
Park and store on a hard, level surface.
Store out of reach of children. Not for use by or around children.
FALLING OFF CAN RESULT IN IMPALEMENT OR BEING RUN OVER.
Tractor must be equipped with a Roll Over Protection Structure (or ROPS CAB) and seat belt.
Keep the foldable ROPS system in “locked up” position at all times.
Keep the seat belt securely fastened.
Never allow riders on equipment.
RAISED EQUIPMENT CAN DROP AND CRUSH.
Before servicing, follow all instructions and safety rules in this Owner’s Manual and securely block
all corners of equipment with jack stands.
Securely blocking prevents equipment from dropping due to mechanical component failures.
FALLING OFF OR FAILING TO BLOCK SECURELY CAN RESULT IN SERIOUS INJURY OR
DEATH.
Assembly Instructions
⚠CAUTION
SCRAPER USE AND CARE
Do not force the scraper. Products are safer and do a better job when used in the manner for
which they are designed. Plan your work, and use the correct product for the job.
Check for damaged parts before each use. Carefully check that the product will operate
properly and perform its intended function. Replace damaged or worn parts immediately.
Never operate the product with a damaged part.
Do not use a product with a malfunctioning switch. Any power tool that cannot be controlled
with the power switch is dangerous and must be repaired by an authorized service
representative before using.
Select an area for assembly that is clean and free of any debris which might cause persons