Owners manual

Step 11: Disassembly Step 12: Packing the tent
1) To take down the tent, disassemble in
reverse order.
2) Remove accessories.
3) Remove and fold fly.
4) Be sure to leave doors and windows
unzipped to avoid zipper damage.
5) Remove stakes with hammers or stake
puller. DO NOT pull on tent.
6) Carefully disengage poles from pins. Push
poles away from you through the sleeves
to minimize risk of damage to tent or poles.
7) Keep poles and stakes together in bags
provided.
1) Spread tent flat, distribute evenly.
2) Fold into quarters not to exceed the length
of pole bag.
3) Lay pole bag at opposite end from door.
Tightly roll bag, skin and fly forcing air
through unzipped door.
4) Secure with ties and place in carry bag with
stakes and accessories.
5) Tent must be clean and dry before storage.
Store off concrete floor.
Be certain campfires are extinguished.
Dispose of trash appropriately.
Dimension A should
be close to but not
exceed the length
of the pole bag.
A
Fold tent into a
rectangular shape.
Front of tent
(door unzipped)
Step 9: Insert closet pole
Tent appears as shown.
Step 10: Secure guy lines
1) To place the closet pole (D) inside the
closet, carefully form an upside - down “U”
and insert to extend and support the
closet.
2) Wrap the Velcro® tabs on the closet wall
around the pole to secure the pole in place.
3) Stake the outside corners.
1) Secure tent using all guy lines and stakes.
Tent must be secured for proper function.
2) Optional mud mat can be attached and
staked into place at the front door.
Step 6: Stake tent Step 7: Attach fly
1) Unfold the fly and place over the tent.
Make sure that the fly awning is over the
front door.
2) Attach the fly to the tent by hooking the
plastic s-hook on the fly corners to the
metal o-rings at the stake loops.
Tent appears as shown.
Step 5: Fasten hooks
1) Stake down the tent by inserting a stake
through the stake loops, located along the
perimeter of the tent.
2) Make certain the tent floor is pulled out
evenly and tightly.
3) Hammer the stakes into the ground at a
45 degree angle using a hammer or mallet.
1) Clip the plastic hooks on the tent to the
fiberglass pole frame.
Step 8: Attach fly pole and fasten the fly
1) Insert the fly pole (C) through the sleeve
found at the edge of the fly awning, over
the front door.
2) Flex the pole and insert each end into the
reinforcement metal grommets located on
each side of the door in the pole sleeve.
3) Wrap the Velcro® fasteners, sewn on the
underneath side of the fly, around the
fiberglass tent poles.
KMT121210 03/13