Owners manual

Disassembly Packing the tent
1) To take down the tent, disassemble in
reverse order.
2) Remove accessories.
3) Remove and fold fly.
4) Be sure to leave doors and windows
unzipped to avoid zipper damage.
5) Remove stakes with hammer or stake
puller. DO NOT pull on tent.
6) Carefully disengage poles from pins. Push
poles away from you through the sleeves
to minimize risk of damage to tent or poles.
7) Keep poles and stakes together in bags
provided.
1) Spread tent flat, distribute evenly.
2) Fold into quarters not to exceed the length
of pole bag.
3) Lay pole bag at opposite end from door.
Tightly roll bag, skin and fly forcing air
through unzipped door.
4) Secure with ties and place in carry bag with
stakes and accessories.
5) Tent must be clean and dry before storage.
Store off concrete floor.
Be certain campfires are extinguished.
Dispose of trash appropriately.
Dimension A should
be close to but not
exceed the length
of the pole bag.
A
Fold tent into a
rectangular shape.
Front of tent
(door unzipped)
Step 6: Secure guy lines
1) Secure tent using all guy lines and stakes. Insert stakes through the guy line loop and
hammer into the ground at a 45
0
angle using a hammer or mallet. Tent must be secured for
proper function.
2) Screen room floor may be attached with hooks and loops. Interior accessories may be attached
to loops inside the tent.
Step 4: Raise the tent
1) To raise the tent, begin by working with a partner at each side of the front door. Remove the
bottom section of the legs poles from adjacent section.This will lower the roof frame to aid in
attaching the fly.
2) Insert the end with the r-spring of the yellow corner leg poles (D) into
the
pre-attached connectors. The yellow corner leg poles (D) will set at an angle toward the center
of the tent.
3) Insert the pink middle leg poles (E) into the connector at the center of the tent.
4) Insert the remaining yellow coded leg poles (D) into the connectors at the back of the tent.
5) Tent appears as shown below.
Step 5: Attach fly and extend the leg poles
1) Unfold the fly. Place over the tent with the tag labelled “Front” over the screen room.
2) Attach the fly to the tent by hooking the plastic s-hook on the fly corners to the metal d-ring
on the corner leg poles. Attach the plastic s-hook to the metal d-ring on the middle leg poles.
3)
Wrap the hook and loop fasteners sewn on the underside of the fly around the tent frame.
4) With 2 persons working on the same side of the tent, complete leg assembly and place the
bottom of the legs onto the pins along the perimeter of the tent floor.
KMT162010 11/15