Owners manual

KMT162010
ASSEMBLY INSTRUCTIONS
Verify package contents
Tent : 1 each
4 way - 4 each 2 way - 8 each
Step 3: Install roof poles
Step 2: Spread tent, stake tent
1) Spread the tent out flat, floor side down.
2) Make certain the tent floor is pulled out
evenly and tightly.
3) Stake down the main tent floor by inserting
the stakes through the stake loops at the
four corners. Insert a stake through the
stake loops at the center of the main floor.
4) With the door closed, stake the screen room
corners.
5) Hammer the stakes into the ground at a
45
0
angle using a hammer or mallet.
Step 1: Assemble poles
1) Assemble steel poles by inserting the
tapered ends into the adjacent sections.
Organize frame poles by color and length.
Seventeen steel poles are provided.
Steel Poles : 17 each (total)
Rainfly : 1 each
Tent Stakes : 22 each Tablet Pocket : 1 each
Hubs : 12 each (total)
Steel Poles :
IMPORTANT NOTES:
* Assemble your tent before camping to become
familiar with the assembly.
* Two people are recommended for setup.
* Select a clean, level area for the campsite free
of debris and sharp objects, away from a
natural watercourse.
* Use of a ground cloth is recommended to
prolong the life of the tent floor and provide
additional insulation and moisture protection.
* To prevent damage to the zippers, unzip the
doors and windows of the tent prior to
disassembly allowing air to move freely.
* Seam seal the inside stitched seams of the tent.
This will improve weather resistance. Available
in sporting goods departments. Discoloration
may occur if applied to outside seams.
(A) Ridge 1 each
(B) Front Roof (Green) 2 each
(C) Middle & Rear Roof (Red) 6 each
(E) Middle Leg (Pink) 4 each
(D) Corner Leg (Yellow) 4 each
(A) Ridge - 1 each (B) Front Roof (Green)
- 2 each
(C) Middle & Rear Roof
(Red) - 6 each
(E) Middle Leg (Pink)
- 4 each
(D) Corner Leg (Yellow)
- 4 each
1) Use the illustration below as guide.
2) Locate the ridge pole (A) with pre-attached color-coded connectors. Verify that the green color - coded hub and hook are attached above the
screenroom.
3) Place over the center of the tent and attach brass s-hooks to the bottom of plastic connectors.
4) Attach green roof poles (B) and red middle and rear roof poles (C) to connectors on the ridge pole and into the pre-attached plastic connectors
along the eaves of the tent. Make certain that pole springs snap into the slots in the connectors.
Divider : 1 each
Hanging Shelf :
2 each
Screen Room Mat :
1 each
KMT162010 11/15