Owners manual

SPECIFICATIONS: 8 persons
Floor size: 18’ x 10’ (5.49 x 3.05m)
Center height: 78” (1.98m)
Weight: 23.13lbs(10.49kgs)
A 2
KEY
NO.
MODEL NO. KMT161810 Quick Camp
QTY.
REQ.
DESCRIPTION
Fiberglass Pole - Main HFP11-275f x 2 + connector
B 2Fiberglass Pole - Side HFP9.5-243f x 2 + connector
C 1Fiberglass Pole - Closet HFP6.3-200c
D 1Fiberglass Pole - Fly
Replacement Fly
HFP6.3-159t
HTFKMT151810 1
Mud mat HMM4723 1
Tent Stake - Metal HMS4-7 20
PART NO.
REPLACEMENT PARTS
C
TROUBLESHOOTING GUIDE
PROBLEM
1. CONDENSATION
2. SEAM LEAKAGE
3. MILDEW
4. REPAIRING A TEAR
5. FAULTY ZIPPER
6. FADING FABRIC
7. FLOOR CONDENSATION
8. USE OF STAKES
SOLUTION
This is caused by lower temperatures on the outside of the tent combined with body heat on the inside of the tent. When this occurs, avoid touching walls to reduce
contact leakage. Leaving the doors and windows open will reduce moisture condensation. Store wet clothing outside of tent. Not applicable to screen houses.
Apply a generous amount of seam sealer on inside seams. Seam sealer may be purchased at any local sporting goods store.
To avoid mildew, store tent/screen house ONLY when thoroughly dry. However, if mildew occurs use a soft bristle brush or sponge with mild dishwashing soap or Fels
Naptha soap to clean. Let dry thoroughly and a tent approved water repellent compound may be applied.
For small tears use a self-adhesive patch kit. We recommend a canvas or awning repair shop for larger tears.
Zippers are self repairing. If the zipper separates, you can move the slider to the beginning of the zipper tape and rework the zipper.
Do not leave up in direct sunlight longer than necessary. If left in sunlight for prolonged periods of time, fabric will fade and weaken.
A ground cloth under the floor helps prolong its life, provides additional insulation and moisture protection. The cloth should be smaller than the floor to prevent rain
from running under the tent. Not applicable to screen houses.
Stakes should be installed at a 45 degree angle using a hammer or mallet. Stake loops should be kept taut without over stretching fabric or webbing. This could cause
tears or leakage. To remove safely, use a hammer or stake puller. Do not remove by pulling on the fabric.
A
A
B
B
D
KMT161810 11/15
1HTP1210Tablet Pocket