Owners manual

KMT161810 Quick Camp
ASSEMBLY INSTRUCTIONS
Verify package contents
Tent : 1 each
Step 2: Spread tent and assemble main and side poles, stake side
Step 1: Assemble poles
1) Assemble the tent poles by placing
fiberglass sections into the metal ferrules
Six poles are provided:
Rainfly : 1 each
Tent Stakes : 20 each
Mud Mat : 1 each
Fiberglass Poles : 6 each (total)
IMPORTANT NOTES:
* Assemble before camping to become familiar
with the assembly.
* Two people are recommended for setup.
* Select a clean, level area for the campsites, free
of debris and sharp objects, away from a
natural watercourse.
* Use of a ground cloth is recommended to
prolong the life of the tent floor and provide
additional insulation and moisture protection.
* To prevent damage to the zippers, unzip the
doors and windows prior to disassembly,
allowing air to move freely.
* Seam seal the inside stitched seams of a tent.
This will improve weather resistance. Available
in sporting goods departments. Discoloration
may occur if applied to outside seams.
(A) 2 each Main (pre-attached to tent)
(B) 2 each Side (pre-attached to tent)
(C) 1 each Closet
(D) 1 each Fly
1) Spread out the tent flat, floor side down.
2) Assemble the tent poles by placing fiberglass section into the metal ferrules.
3) Place main pole (A) and side pole (B) into the connectors attached to the tent.
4) Insert stakes into the two stake loops at the opposite end from the easy-set loop. Hammer
the stakes into the ground at a 45
0
angle using a hammer or mallet.
A
BB
A
(A) 2 each Main (pre-attached to tent)
(B) 2 each Side (pre-attached to tent)
(C) 1 each Closet
(D) 1 each Fly
Step 3: Attach poles to fast feet
1) Begin at staked end of the tent. Have one person place and hold an end of the side pole (B)
into the nearby fast foot along the floor of the tent. On the opposite side of the tent, a
second person takes hold of the other end of the same pole. The pole is then flexed into an
arch and carefully placed onto the corresponding fast foot. Lay the pole down, with the
pole middle toward the staked end as shown below.
2) Repeat the procedure for the remaining fiberglass poles (A) and (B).
KMT161810 11/15
Tablet Pocket :
1 each