Owners manual
1) Unfold the fly and place over the tent.
2) Attach the fly to the tent by attaching the plastic s-hook on the fly corners to the d-ring at the tent corners.
3) Insert the fly pole (B) through the sleeve found at the edge of the fly awning, over the front door.
4) Flex the pole and insert each end into the reinforced metal grommets located in in the pole sleeves on either side of the door.
5) Wrap the hook and loop fasteners, sewn on the underside of the fly, around the fiberglass tent poles.
Step 7: Fully assembled
Tent appears as shown.
Step 6: Secure guy lines
1) Secure tent using all guy lines and stakes. 1) To take down the tent, disassemble in
reverse order.
2) Remove accessories (if included).
3) Remove and fold fly.
4) Be sure to leave doors and windows
unzipped to avoid zipper damage.
5) Remove stakes with hammers or stake
puller. DO NOT pull on tent.
6) Keep stakes in bags provided.
Disassembly
Step 5: Attach fly and secure fly pole
1) Stake down the tent by inserting a stake
through the stake loops, located along the
perimeter of the tent.
2) Make certain the tent floor is pulled out
evenly and tightly.
3) Hammer the stakes into the ground at a
45
0
angle using a hammer or mallet.
Step 4: Stake tent
Tent must be secured for proper function.
Gear loft may be hung from fabric loops
inside tent.
Optional mud mat may be toggled and
staked into place.
Airport may be staked out for added ventilation.
Sides of the fly may be opened for added
ventilation.
1) Spread tent flat, distribute evenly.
2) Position pre-attached poles parallel to
each other. See example below.
Fold tent into quarters and again in half.
3) Tightly roll tent forcing air through unzip-
ped openings.
4) Secure with ties and place in carry bag with
stakes and accessories.
5) Tent must be clean and dry before storage.
Store off concrete floor.
Packing the tent
Folded tent
(openings unzipped)
KMT161008 11/15