Product Manual

Towing Instructions
7
and licensing). Be sure receiver on towing vehicle is bolted tightly. Towing vehicle
capability must be matched to trailer weight and type of hitch arrangement
1. Attach Stump Grinder coupler to a class 2 or higher hitch with 2” ball (only).
2. Adjust coupler to ball by raising locking lever and turning lock nut with fingers.
3. Proper adjustment is obtained when coupler is as tight as possible on ball and
locking lever can still be opened and closed.
4. Close the lock lever to secure the attachment. An optional locking pin or padlock
may be inserted in the locking lever hole for extra security.
5. Attach safety
chains
Attach safety chains.
1. Two safety chains must be used while towing.
2. Cross safety chains under the coupler allowing only enough slack for vehicle
turns.
6. Tow to desired
location
Tow Stump Grinder carefully to desired work site.
Important safety instructions:
• Speed limit. Never tow this Stump Grinder over 45 mph. Faster speeds may
result in loss of control.
• Added length. Be aware of the added length of the Stump Grinder.
• Rough terrain. Drive slowly and take extra caution when traveling over
rough terrain.
• On public roads. If towing on a public road, make sure to comply with all
local, state, and federal towing requirements. It is the sole responsibility of
the purchaser to obtain licensing, trailer lights, safety chains or signage, as
needed to comply.
• Unattended. Turn off the towing vehicle before leaving the Stump Grinder
unattended.
• Under the influence. Never tow or operate this Grinder while under the
influence of alcohol, drugs, or medication
7. Remove tow bar
& safety chains
after towing.
Remove tow bar and Safety chains after towing and before operating your
Stump Grinder.
NEVER operate Stump Grinder while the Tow Bar or Safety Chains are attached.