Product Manual

22
Assembly
Step 8 – Pump to Tank Assembly
 Apply soap to bypass fitting on regulator.
 Press bypass fitting into the grommet.
 Install (1) long screw through tether, washer and front left
pump foot and into threaded hole in tank until tight.
 Install (3) short screws through washers and pump feet and
into threaded holes in tank until tight. Note: damage to
rubber pump feet could occur if screws are over-tightened.
Tools Needed
 Phillips head
screwdriver
Fasteners Needed from Owner’s Manual Bag:
#10-24 x 1” Screw
Qty 3
82061
#10 Washer
Qty 4
82068
#10-24 x 1 1/8” Screw
Qty 1
82617
Washer
#10-24 x 1”Screw
#10-24 x 1 1/8”Screw
Tether