M22851A.2 Owner's Manual Remote Switch: Outdoor agricultural sprayer kit used to remotely turn On/Off the boom. WARNING Read this manual. Serious injury or death can result if safety instructions are not followed. Everyone who operates this machine must read and completely understand all safety rules, operating instructions, and maintenance instructions.
Hazard Signal Word Definitions 2
Table of Contents Important Safety Rules .................................................4 Unpacking.........................................................................5 Assembly Instructions ......................................................6-10 Operation Instructions ..................................................11 Parts Breakdown .............................................................
Important Safety Rules WARNING 1.) Read this manual completely. Serious injury or death can result if safety instructions are not followed. -Everyone who operates the sprayer must read and completely understand all safety rules, operating instructions, and maintenance instructions. -You must be 16 years of age or older to operate this sprayer. 2.) Chemicals are dangerous. Serious injury or death can result if chemical manufacturer's instructions are not followed.
Unpacking Closely inspect all contents in the shipping carton. - If you have missing or damaged components then: Contact Product Support at 1-800-270-0810.
Assembly Instructions 1.) -Drill two ¼” holes on tongue of frame (if necessary). 2.) –Attach solenoid valve to tongue with the lock washers and screws.
Assembly Instructions 3.) -Splice the boom supply hose near the hose barbs on the solenoid valve. 4.) –Install the boom supply hoses to the solenoid valve. Follow the hose clamp instructions. Hose clamp installation instructions: I.) Slide hose clamp over the end of hose. II.) Push the hose onto the hose barb. III.) Slide the hose clamp over the hose barb. IV.) Tighten the hose clamp.
Assembly Instructions 5.) -Connect the solenoid wire to the solenoid valve.
Assembly Instructions 6.) -Disconnect the vehicle battery ground wire. -Connect the bare end of the red wire of the battery power cord to positive(+) terminal of the battery. -Connect the bare end of the black wire of the battery power cord to negative(-) terminal of the battery. -Reconnect the vehicle battery ground wire. - When you would like to spray, put the remote switch in the "OFF" position. -Connect the battery power cord to the remote switch (red wire to red wire).
Assembly Instructions 5.) Before operating the sprayer with chemicals, test for leaks, and learn the sprayer operation. A. Fill the tank with water. B. Connect the power cords to the solenoid valve. Turn the remote switch off. C. Start the sprayer per the 282711 owner’s manual. D. Open the boom ball valve. E. Turn on the remote switch, the boom should begin to spray. F. Check for leaks throughout the system. If a leak is detected, fix the leak and re-test the system. WARNING Assembly is now complete.
Operation Instructions Proper Operation of the Remote Switch 1.) 2.) 3.) 4.) 5.) Connect the power cords to the solenoid valve. Turn the remote switch off. Start the sprayer per the 282711 owner’s manual. Open the boom ball valve. Turn on the remote switch, the boom should begin to spray. Follow the 282717 owner’s manual for boom spraying instructions. If you do not have the 282717 instructions call product support for a copy. Turn off the remote switch to stop the spray from the boom.
Exploded View - Item # 22851 Rev. A.2 Item Part Number 1 2 3 4 5 6 7 8 9 10 11 12 13 14 37693 37694 34026 5260 35363 777855 777119 779269 30844 82059 82069 5301 5282 777857 Description Qty.
This page has been intentionally left blank.
Manufactured by Northern Tool + Equipment Co., Ltd. Burnsville, MN 55306 NorthernTool.
