Product Manual

E94992A

WARNING

Batteries are hazardous because they contain caustic acid, can emit explosive

gases, and can cause electric shock.

Caution must be exercised when making connections to a battery to avoid shock

and contact with the acid, and to prevent any sparking that could lead to an

explosion.

ALWAYS follow the safety instructions and steps listed below in exact sequence

when connecting the wire harness to the battery terminals.

ASSEMBLY INSTRUCTIONS

1. Preparatory safety

Preparatory safety steps:

 ALWAYS use eye protection

 NEVER smoke or work near sparks or other sources of ignition.

 NEVER touch both battery terminals at the same time or with any non-insulated

tools.

 If battery acid contacts skin or clothing, flush immediately with water and

neutralize with baking soda.

2. Connect to battery

Connect the wire harness to the vehicle battery using the following procedure:

a) Disconnect the vehicle battery ground wire.

b) Connect the wire harness’ red battery clamp to the positive (+) terminal of the

battery.

c) Connect the wire harness’ black battery clamp to the negative (-) terminal of the

battery.

d) Reconnect the vehicle battery ground wire.

WARNING: Always connect in this sequence to avoid possible shock.

ITEM NUMBER: 94992

SERIAL NUMBER: _____________

PAGE 1
E94992A ITEM NUMBER: 94992 SERIAL NUMBER: _____________ WARNING Batteries are hazardous because they contain caustic acid, can emit explosive gases, and can cause electric shock. Caution must be exercised when making connections to a battery to avoid shock and contact with the acid, and to prevent any sparking that could lead to an explosion. ALWAYS follow the safety instructions and steps listed below in exact sequence when connecting the wire harness to the battery terminals. ASSEMBLY INSTRUCTIONS 1.
PAGE 2
3. Connect cords together Connect the wire harness to the pump power cord. a) Check to be sure the power switch is in the "OFF" position on the wire harness. b) Connect the wire harness to the pump power cord. To Battery Wire Harness FIG06205 Pump power cord 4. Disconnect after use AFTER EACH USE, disconnect power to the sprayer by disconnecting the sprayer's wire harness battery clamps from the battery.