Product Manual

Assembly
10
Step 2 – Inlet and Outlet Fitting Installation
 Install either the QC x 1/2 HB fitting or QC x ½ MNPT fitting into either
inlet port at the bottom of the pump manifold.
o Use a flat blade screwdriver to remove QC clip from the pump before
installing fitting. Snap QC clip back into pump after fitting is inserted.
Note: The pump is configured for installing the inlet fitting in the left side of
the manifold. If the right side preferred, the QC plug must first be moved
from the right side inlet port to the left side inlet port.
 Install any QC fitting into the regulator outlet port.
o
Use a flat blade screwdriver to remove QC clip from the regulator before
installing fitting. Snap QC clip back into regulator after fitting is inserted.
Tools Needed
 Flat blade
screwdriver
05915
05914
QC Clip
Inlet fitting
(787209 shown)
Outlet fitting
(787208 shown)
QC Clip
Regulator outlet port
Pump inlet