Product Manual

Assembly Instructions

Hose Needed:

Tools Needed

• 1” Wrench

• 7/8” Wrench

• Crescent Wrench

(2 Needed)

Step 18 – High Pressure Hose Routing Cont’d

• Remove plug from pump.

• Screw finger-tight (1) Hydraulic Pump Fitting into the pump

• Wrench-tighten the fitting to 1.5-3.0 Turns Past Finger Tight position.

Consider final orientation position as to not exceed the recommended TPFT.

Properly assembled fittings total thread engagement should be 3.5-6 turns.

• CAUTION: Never back off an installed pipe fitting to achieve proper

alignment. Loosening installed pipe fittings will corrupt the seal and

contribute to leakage and failure.

• Route (1) Long High Pressure Hose from the Valve to Hydraulic Pump

Fitting on the control valve to the Hydraulic Pump Fitting

• Screw finger-tight Long High Pressure Hose to Valve to Hydraulic Pump

Fitting

• Wrench tighten 1.5-3.0 Turns Past Finger Tight

• Screw finger-tight remaining end of Long High Pressure Hose to the

Hydraulic Pump Fitting

• Wrench tighten 1.5-3.0 Turns Past Finger Tight

Valve to Hydraulic Pump

High Pressure Hose, 56” x 1/2” ID with

1/2” Male NPT fittings

Qty 1

Valve Fitting

Long High

Pressure Hose

Tow Bar

Hose Guide

Hydraulic Pump

Pump Fitting

Pump

Pump Fitting

Remove

plug