Product Manual

Assembly Instructions

Step 8 – Suction Hose from Tank to Pump

• In step 6, a piece of suction hose was installed to the fitting on the

hydraulic tank assembly.

• Locate the other end of the suction hose and the hydraulic pump as

show below.

• Loosen hose clamp as necessary. Slide hose clamp onto end of suction

hose and push onto pump fitting.

• Secure and tighten hose clamp around the suction hose and pump

fitting. Torque to 78 in.-lb.

• Hose clamp must have a tight seal to prevent hydraulic oil from

leaking.

Tools Needed

• Flat Blade Screw

Driver

• Torque Wrench

Hydraulic Pump

Suction Hose

Hose

Clamp

Pump Fitting

Tank to Pump Hose Clamp

Qty 1

110900 and 1131 Only

Tank to Pump Hose Clamp

Qty 1

110800 Only

Fasteners Needed from Parts Bag: